Address: 511 E Main St, Arlington, TX 76010, USA
Phone: +18172619022
Sunday: Closed
Monday: 8AM–6PM
Tuesday: 8AM–6PM
Wednesday: 8AM–6PM
Thursday: 8AM–6PM
Friday: 8AM–6PM
Saturday: Closed
Renegade Ray
I have used Eddie for the machine work for my custom rod shop for years. I was very happy until recently. 1st was a missed Crack in a SBF during magniflux that was fully machined assembled and installed in an open engine 32 model A. The "tabs" he recommended wouldn't stop the coolant leak and I had to install a crate engine to make the customer happy. 2nd a fully machined vortec block with the wrong center 3 main caps that where loose and didn't line up , but they did take the time to stamp them. Even though they weren't correct for that block. Again time and money wasted. Crate engine to make customer happy. they do good work but attention to detail is everything in the machine shop biz. You had better check the work they do before it leaves thier shop.
Dylan Garcia
Great quality work for a fair price did a great job resurfacing the heads to my Land Rover v8 for my head gasket job 😎
Corey Bryant
Sent my SBF in to get it set up for a stroker I built and everything was on point. They know their trade and do good work.
Kevin Hanson
Used Eddie back in 2010 to clean up my Ls2 and install my cam bearings for me. Its still running strong to this day in my 07 Trailblazer SS
Thanks! Your review is awaiting moderation.
What kind of heads are we asking about ? Are we asking about a valve job ?
Let us know what you need done and I bet we can. We still do a fair amount of work on the old school engines. We currently have a flat head v8 Ford engine , A Model T engine, a 1950 Nash flat head 6 and a 1940 model flat head v8 Cadillac we are working on now. Leave me a message on the answering machine and I will call you back. Thanks, Eddy Adams (817) 261-9022
We only are doing machine work on engines at this time because of our back log. The basic machine work on the engine block would be around $500. If the crank had to be machined it would be $85. A valve job on both of the cylinder heads would be $225.00 This is for machine work only . You would still need to buy parts for the engine.
No. They are a strictly a machine shop.
Thanks! Your answer is awaiting moderation.
Thanks! Your question is awaiting moderation.