Eagle Access Control Systems

Might wanna check your limits. If the gate closes and once it reaches the end it reopens it might be because the closing limit is not adjusting properly.

Check that the chain is not too tight

Press en hold the button on ur car n when it blinks release n then press twice. Then wait 5 second then press n will open

Lubricant/grease from home depot is cost like 4 dollars the tube you can do it by you self is easy.

The photo eye sensor is when a vehicle is passing through the gate while the gate is half way closing, the sensor stops the gate and re-opens. This is a must for emergencies, I would suggested installing it.

Yes there is a reset button on the board him self, and one more side of the gear it's a red button

Check your primary and secondary connections. The wiring might be going bad between both operators which in turn misfires the signal from primary to secondary operator.

Make sure your boar is puting voltage to the receiver some times if is an after market receiver you need its own power source

Theres a limit switch on the separate box.it need to be adjusted one click at a time.